Selection Note for Replica Rims

1\Installing surface of the replica wheels screw:

There are some shapes for the replica rims like sphere, cone and plane . The combination surfaces between the replica alloy wheel and the screw are mostly spherical, while the modified replica alloy wheel because of the difficulty of processing more choice of cone problem is sure to replace the screws; the screw surface is used in a large car, rare car.

2, the replica alloy wheel screws in replica rims

The normal design of the screw hardness of the original car is not high. The screw or screw hole column hardness is much lower, so the aim is not to damage the brutal dismantling wheels, brakes, or brake drum, the thread, so that The premature retirement.

However, some modification of stainless steel screws used very hard materials, in particular within the six removable screw holes, although it beautiful, but must be careful when dismantling, according to the instructions of the wheel vehicle screw tightening torque, must not be over- force.

3 screws in the form of replica rims

Some modifications required by the special screw head within the six sets of removable, and some screws screw disassembly surface does not match the original car (such as the mouth of the original car is 18mm, while the conversion is 16 with the screw) of the original car's wheels can not use screw disassembly tool, and need another spare set of tools.

There is only modified for the four laps in the replica rims also used to do a backup, if the screw, the tool can not be universal, the car had prepared two sets of tools and a removable screw the original car, or out of the problem would be very embarrassed.